OmniSistem PR Pilot 150 - Manual (Page 7)

TO SET THE DMX START ADDRESS
Press the UP or DOWN buttons and the display will show the DMX start address.
Confirm your choice by pressing the ENTER button, this will save and set the DMX start address.
The display will show the latest setting each time the projector is powered up.
To control the projector with a DMX controller the DMX start address must be set.
Ensure that none of the Stand-Alone options are set or they will interfere with correct DMX operation.
DMX CONTROL CHANNEL FUNCTIONS
The PILOT 150 uses 8 DMX channels. They are listed in the following table.
CHANNEL DMX VALUE DESCRIPTION
Open / Clear
0-33
5-7: Holding for 3 seconds, the unit will reset and then restart
34-66 GOBO 1 (Swirl)
67-99 GOBO 2 (Tri-ring)
100-132 GOBO 3 (Windmill)
133-165 GOBO 4 (Multi-circle)
166-199 GOBO 5 (Stars)
200-232 GOBO 6 (Ring)
1
GOBO WHEEL
233-255 GOBO 7 (Three-prong)
0-8 Stop
9-163
Orientation from 0°to 360°
164-205 Rotate from slow to fast
206-213 Stop
2
GOBO
ROTATION
214-255 Rotate in opposite direction from slow to fast
0-27 Open (White)
28-55 Red
56-83 Yellow
84-111 Light
green
112-139 Pink
140-167 Ultraviolet
colour
168-195 Cyan
196-223 Green
224-251 Blue
3
COLOUR
WHEEL
252-255 Orange
0-21 Black-out
022-110
Open gradually from black to full open (dimming)
111-135 Open
136-247
Strobe adjust from slow to fast (1 ~7 flashes / sec.)
4
STROBE
248-255 Open
5 PAN 0-255 Pan movement from 0°to 370°
6 TILT 0-255 Tilt movement from 0°to 265°
7 PAN 16BIT 0-255 16 Bit Pan movement (High-resolution)
8 TILT 16BIT 0-255 16 Bit Tilt movement (High-resolution)
NOTE:
The channels 7 and 8 are only available when the Setup Option 6 (high resolution) is “ON”.
For the exact setting refer to “Setup Options – Projector Configuration” above.
STAND – ALONE MODE
To operate the projector without connecting a controller, enable a combination of setup options 3, 4 and 5, the
projector will run in Stand-Alone mode with or without sound activation depending on the options that have been
selected. See the section on “Setup Options – Projector Configuration” for full details of the available
combinations.
7/14 pilot 150 manual.doc