OmniSistem PR Pilot 150 - Manual (Page 4)

INSTALLING THE PROJECTOR
M8x25
Bolt
Bracket
Fixing
Hole
M8x25
Bolt
Pass safety fixing
through these holes
The projector should be mounted via its bracket using one M12 bolt. The bracket itself attaches to the underside
of the projector with two (2) M8x25 bolts provided. Always ensure that the projector is firmly anchored to avoid
vibration and slipping whilst operating. Always ensure that the structure to which you are attaching the projector
is secure and is able to support a weight of 11.5Kg for each PILOT 150. For safety the projector should have a
secondary fixing with a safety chain through the holes on the underside of the unit.
WARNING: The projector should NEVER be lifted or carried by the yoke.
FITTING THE LAMP
LAMP ACCESS HATCH
LAMP ADJUSTMENT
LAMP ADJUSTMENT
ACCESS SCREW
ONLY USE REPLACEMENT
LAMP TYPE: HTI 150W
LAMP ADJUSTMENT
ACCESS SCREW
Adjust lamp
position by
turning screws
A, B and C
HTI 150W LAMP
LAMP HOLDER
LAMP ACCESS HATCH
Open the lamp access hatch at the rear of the projector by undoing the 2 access screws as shown above.
Insert an HTI 150W/DX lamp in the lamp holder. Close the access hatch carefully and retighten the 2 access
screws.
NOTE: To optimize light output it will be necessary to adjust the lamp alignment to obtain an even distribution
of light within the beam. The three screws (marked A, B, and C) may be gently turned to center the lamp within
the reflector. The projector should be switched on with the shutter open and the beam focused to do this, it is
also advisable to allow the lamp 5 minutes to come up to full brightness before starting to align it. Note: the three
screws will only need a small adjustment to centre the lamp, do not try to unscrew them completely. Read the
rest of this manual and then come back to this section to align the lamp.
The HTI series are high pressure lamps with external igniters . Care should always be taken when handling
these lamps. Always read the manufacturers "Instructions for use" enclosed with the lamp.
4/14 pilot 150 manual.doc