OmniSistem PR Pilot 150 - Manual (Page 6)

DMX TERMINATOR
At the last fixture in the chain, the DMX output has to be connected with a DMX terminator. This prevents
electrical noise from disturbing and corrupting the DMX control signals.
The DMX terminator is simply an XLR connector with a 120
Ω (ohm) resistor connected across pins 2 and 3,
which is then plugged into the output socket on the last projector in the chain. The connections are illustrated
below.
PIN 3
PIN 2
DMX TERMINATOR
CONNECTION
Connect a 120
Ω(OHM) resistor across pins
2 and 3 in an XLR plug and insert into the
DMX OUT socket on the last unit in the
chain.
SETUP OPTIONS – PROJECTOR CONFIGURATION
To browse through the various Setup Options, press the FUNC button consecutively. There are 6 Option codes
(1~6), and each code has a specific function. The functions provided are listed in the following table.
CODE CHOICE FUNCTION
1 Y Tilt inversion enable-Tilt is inverted
1 N Tilt inversion disable-Tilt is normal
2 Y Pan inversion enable-Pan is inverted
2 N Pan inversion disable-Pan is normal
3 Y Sound control (effect 1) enable
3 N Sound control (effect 1) disable
Y 3
4
Y
Sound control (effect 2) enable
3 N
4
Y or N
Sound control (effect 2) disable
5 Y Automatic programmes (effect 1) enable
5 N Automatic programmes (effect 1) disable
4
5 Y
Y
Automatic programmes (effect 2) enable
4
5 N
Y or N
Automatic programmes (effect 2) disable
6 Y 16bit Pan/Tilt movement resolution enable
6 N 16bit Pan/Tilt movement resolution disable
Once you have selected the desired operation code, press the key UP or DOWN to select either “n” (means
OFF) or “y “ (means ON). n = NO, y = YES.
Press the key ENTER to save the selected function and configuration. If the display is showing “y”, then the
setting has been enabled. In the same way, if it was showing “n” when you pressed ENTER the option has
been disabled.
The Red LED will flash during this operation.
PROJECTOR DMX START ADDRESS
GREEN LED RED LED
FUNC DOWN UP ENTER
Each PILOT 150 must be given a DMX start address so that the correct projector responds to the correct
control signals. This DMX start address is the channel number from which the projector starts to “listen” to the
digital control information being sent out from the controller. The PILOT 150 has 8 channels, so set the No. 1
projector’s address 001, No. 2 projector’s address 009, No. 3 projector’s address 017, No. 4 projector’s address
025, and so on.
The display shows the DMX start address after the projector is switched on (if you have already set the DMX
start address and saved it, the screen will display the last setting).
6/14 pilot 150 manual.doc