OmniSistem PR Moon - Manual (Page 8)

Moon-halogen manual.doc 8/14
SETUP OPTIONS - PROJECTOR CONFIGURATION
To browse through the various Setup Options, press the FUNC button consecutively. There are 11
option codes (1~9 and A, b), each code has a specific function. The functions provided are listed in
the following table.
CODE CHOICE FUNCTION
Y Pan inversion enable - Pan is inverted
1
N Pan inversion disable - Pan is normal
Y Tilt inversion enable - Tilt is inverted
2
N Tilt inversion disable - Tilt is normal
Y Sound activation enable
3
N Sound activation disable
Y Automatic programmes enable
4
N Automatic programmes disable
5 Reserved for possible future development
6 Reserved for possible future development
Y Reset enable
7
N Reset disable
8 When enable, colours changing in linear
9 Reserved for possible future development
A Reserved for possible future development
B Reserved for possible future development
Once you have selected the desired operation code, press the key UP or DOWN to select “n”
(means OFF) or “y “ (means ON). N = ON, Y = YES.
Press the key ENTER to save the selected function and configuration. If the display is showing “y”,
then the setting has been enabled. In the same way, if it was showing “n” when you pressed ENTER
the option has been disabled.
The green LED will flash during this operation.
OPERATION