OmniSistem PR Moon - Manual (Page 5)

Moon-halogen manual.doc 5/14
Use the plug provided to connect the mains power to the projector paying attention to the voltage and
frequency marked on the panel of the projector. It is recommended that each projector is supplied
separately so that they may be individually switched on and off. It is recommended that
the
green/yellow must be earthed correctly.
XLR CONNECTORS
Connection between controller and projector and between one projector and another must be made
with 2 core screened cable, with each core having at least a 0.5mm diameter. Connection to and
from the projector is via cannon 3 pin XLR plugs and sockets which are included with the projector.
The XLR's are connected as shown in the table above.
Note, care should be taken to ensure that none of the connections touch the body of the plug or each
other. The body of the plug is not connected in any way. The MOON accepts digital control signals in
standard DMX512 (1990) format.
CONNECTING CONTROLLER WITH PROJECTORS
Connect the controller’ s output to the first fixture’ s input, and connect the first fixture’ s output to the
second fixture’ s input. The rest may be deduced by analogy. Eventually connect the last fixture’ s
output to a DMX terminator as shown in the figure below.
In Controller mode, the red LED near the display screen is blinking means the projector is receiving
the DMX 512 signal normally.
POWER SUPPLY - MAINS
CONTROL CONNECTIONS