OmniSistem PR Mantis - Manual (Page 7)

Mantis manual.doc 7/12
Without using the controller, many projectors can
run synchronously by linking them with each other
in the Master/Slave mode.
Select one projector as the master without
connecting any cable to the projector’
s input, and
set DIP switches as shown on the right.
Regard the other projectors as the slaves, and set
the DIP switches as shown on the right.
Connect the master’
s output to the first slave’ s
input, and connect the first slave’ s output to the
second slave’ s input. The rest may be deduced by
analogy. Eventually connect the last slave’ s output
to a DMX terminator as shown in the figure above.
In the Master/Slave mode, all slaves will change
colours and gobos synchronously according to the
master.
CONNECTING THE CONTROLLER WITH THE UNITS
Connect the controller’
s output to the first projector’ s input, and connect the first projector’ s output to
the second projector’ s input. The rest may be deduced by analogy. Eventually connect the last
fixture’ s output to a DMX terminator as shown in the figure below.
The red LED indicator blinking means the projector is receiving DMX 512 signal normally.
MASTER / SLAVE SYNCHRO MODE
CONTROLLER MODE - DMX OPERATION