OmniSistem OnyxPro 132 - Manual (Page 9)

The projector needs to be installed out of reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems need to be used. The
projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the safety of a
possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
The unit can be placed directly on the stage floor or rigged in any orientation on a truss without altering its
operation characteristics (see the drawing).
The fixture base enables mounting in two
ways.
For overhead use (mounting height
>100cm), always install an appropriate
safety bond.
Please note: for overhead rigging in
public or industrial areas, a series of
safety instructions in this manual need
to be followed. The operator must inform
themselves on the current safety
instructions and consider them.
9 of 26