OmniSistem OnyxPro 132 - Manual (Page 22)

Sequence
With this function, you can run the internal program. You can select the desired program under “Select Chase”.
You can set the number of steps under “Edit Chase”. You can edit the individual scenes under “Edit Scenes”.
With this function you can run the individual scenes either automatically, i.e. with the adjusted step time. The
selection "Alone" means stand alone mode and "Master" that the device is defined as master.
Music
With this function you can run the internal program in sound­controlled mode. The selection "Alone" means
stand alone mode and "Master" that the device is defined as master.
Select Chase for Auto Program
With this function you can select the program for the Program Run.
Edit Chase
With this function you can edit the internal programs.
Edit scenes
With this function you can edit the scenes of the internal programs.
Rec. Controller
The device features an integrated DMX recorder that allows you to transmit the programmed scenes from your
DMX controller to the device. Adjust the desired scene numbers by pressing Up or Down. When you call up the
scenes at your controller, they will automatically be transmitted to the device.
Excursion:
A master unit can send up to three different data groups to the slave units, i.e. a master unit can start three
different slave units, which run three different programs. The master unit sends the three program parts in a
continuous loop.
The slave unit receives data from the master unit according to the group which the slave unit was assigned to. If
e.g. a slave unit is set to “Slave 1” in the menu “Set to Slave”, the Master unit sends “Auto Program Part 1” to
the Slave unit. If set to “Slave 2”, the slave unit receives “Chase Part 2”.
To Start an Auto Program Proceed as Follows:
Slave Setting
1. Select “Program” by pressing Up or Down.
2. Press the Enter-button to confirm.
3. Select “Slave” by pressing Up or Down.
4. Press the Enter-button to confirm.
5. Press Up or Down to select “Slave 1”, “Slave 2” or “Slave 3”.
6. Press the Enter-button to confirm.
Automatic Program Run
1. Select “Program” by pressing Up or Down.
2. Press the Enter-button to confirm.
3. Select “Sequence” by pressing Up or Down.
4. Press the Enter-button to confirm.
5. Press Up or Down to select “Master” or “Alone”. The selection "Alone" means Stand Alone-mode and
6. "Master" that the device is defined as master.
7. Press the Enter-button to confirm.
Program for Select Chase
1. Select “Edit Chase” by pressing Up or Down.
2. Press the Enter button to confirm.
3. Select “Select Chase” by pressing Up or Down.
4. Press the Enter button to confirm.
5. Press Up or Down to select “Chase Part 1”, “Chase Part 2” or “Chase Part 3”, and thus select which
22 of 26