OmniSistem OnyxPro 75 - Manual (Page 17)

The objective lens will require weekly cleaning as fog/smoke machine fluid tends to build up residues, reducing
the light output very quickly. The cooling fans should be cleaned monthly.
The interior of the fixture should be cleaned at least annually using a vacuum cleaner or an air jet.
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried out
by authorized dealers.
Replacing the Fuse
Only replace the fuse by a fuse of same type and rating.
Procedure:
Step 1: Remove the fuse holder on the rear panel.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it needs to be replaced with a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power Supply: 100­240V AC, ~50/60 Hz
Power Consumption: 160W
DMX Control Channels: 11/14
DMX­512 Connection: 3­pin XLR
Sound Control: Built­in Microphone
Light Source: 75W White LED
Beam Angle: Approx. 13° to 18°
Color Wheel: 8 Dichroic Filters + Open
Rotating Gobo Wheel: 7 Gobos + Open
17 of 18