OmniSistem OnyxPro 75 - Manual (Page 16)

unit off. (Activates after
5 minutes.)
Adju CHXX=XXX Adjust Value of Each
Channel
Info DriT XXXC Driver Temperature
Set Rest Rest Reset
Move RPan ON/OFF
RTilt ON/OFF
Degr 630/540
Enco ON/OFF
Mode Mod1/Mod2 Reverse Pan
Reverse Tilt
Choose Pan Degree
Encoder Wheel
Choose Pan/Tilt Mode
UI Mic 0~99%, 60%
Sign Close/Hold/Auto/Music
Fan Auto Speed/High Speed
Hibe OFF, 01M~99M, 15M
Back 02~60M, 02M
Flip ON/OFF
User Use1/Use2 Mic Sensitivity
Signal Mode
Fan Mode
Hibernate Time
Backlight Time
Flip Display 180°
DMX Mode (St/Ex)
Cali Code XXX
CHXX XXX Password (050)
Calibrate Channel
Ver X1.0.0 IC Version
load ON/OFF Reload Default
CLEANING AND MAINTENANCE
The operator needs to make sure that safety­related and machine­technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator needs to make sure that safety­relating and machine­technical installations are inspected by a
skilled person once a year.
The following points must be considered during the inspection:
1) All screws used for installing the devices or parts need to be tightly connected and not corroded.
2) There must not be any deformations on housings, fixations, and installation spots (ceiling, suspension,
trussing).
3) Mechanically moving parts like axles must not show any traces of wearing (e.g. material abrading or
damages) and must not rotate unbalanced.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables), or
sediments. Further instructions depending on the installation spot and usage need to be adhered by a skilled
installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint­free cloth. Never use alcohol or
solvents!
16 of 18