OmniSistem OnyxPro 101 - Manual (Page 9)

The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base. Pull the safety bond over
the trussing system. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20cm.
A safety bond which already holds the strain of a fall or which is defective must not be used again.
1. Omega Holder
2. Clamp
3. Safety Cable
4. Quick Lock
Fastener
Screw the clamp via a M12
screw and nut onto the
Omega holder.
Insert the quick­lock
fasteners of the Omega
holder into the respective
holes on the bottom of the
device. Tighten the
quick­lock fasteners fully
clockwise.
9 of 27