OmniSistem OnyxPro 101 - Manual (Page 4)

OPERATING PROCEDURES
This device is a moving head light for creating decorative effects. This product is only allowed to be operated with
an alternating voltage of 100­240V, 50/60 Hz and was designed for indoor use only.
This device is designed for professional use, e.g. on stages, in clubs, bars, theatres, etc.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the device
will serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or operating the device.
Never lift the fixture by holding it at the projector head, as the mechanics may be damaged. Always hold the
fixture at the transport handles.
When choosing the installation spot, please make sure that the device is not exposed to extreme heat, moisture
or dust. There should not be any cables lying around. Please make sure that the unit cannot be touched or
bumped.
This device must never be operated or stockpiled in surroundings where water splash, rain, moisture or fog may
harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical shocks.
When using smoke machines, make sure that the device is never exposed to the direct smoke jet and is installed
in a distance of 0.5 meters between smoke machine and device. The room must only be saturated with an amount
of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between ­15°C and +45°C. Keep away from direct heat (particularly in
cars) and heaters.
The relative humidity must not exceed 50% with an ambient temperature of 45° C. This
device must only be operated in an altitude between ­20 and 2000 m over sea level.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the device
during thunderstorms.
This symbol determines the minimum distance from lighted objects. The minimum distance
between light output and the illuminated surface must be more than this value.
The device must only be installed on a non­flammable surface. In order to safeguard sufficient ventilation, leave
50cm of free space around the device.
The housing must never touch surrounding surfaces or objects.
Make sure that the area below the installation place is clear when rigging, derigging or servicing the fixture.
For overhead use (mounting height >100 cm), always fix the fixture with an appropriate safety cable. Fix the safety
cable at the correct fixation points only. The safety cable must never be fixed at the transport handles!
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly fastened.
The maximum ambient temperature T
a
= 45°C must never be exceeded.
Operate the device only after having become familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons and
will void your warranty.
Never remove the serial barcode from the device as this would void the warranty.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short­
circuit, burns, electric shock, crashing, etc.
4 of 27