OmniSistem OnyxPro 101 User Manual

Page 20

Initial status
With this function you can display which value the respective channels will start.

Error channels
With this function you can display the channel errors.

Fixture Model
With this function you can display the model number and brand of the fixture.

Software version
With this function you can display the software version of each IC.

1. Select “Software ver.” by pressing Up or Down.
2. Press the Enter button. The display shows e.g. “1U01 VX.X.XX”, “X.X.XX“ stands for the version number.

Set

Reset
With this function you can reset the device via the Control Board. You can select the different Reset functions
by pressing Up or Down.

Movement

PAN Reverse
With this function you can reverse the pan movement.

TILT Reverse
With this function you can reverse the tilt movement.

PAN Degree
With this function you can select the pan degree.

1. Select “PAN degree” by pressing Up or Down.
2. Press the Enter button, the display shows “540”.
3. Press Up or Down to select the desired degree between “540” and “630”.
4. Press the Enter button to confirm.

Automatic PAN/TILT calibration
With the function "Encoders" you can calibrate the pan/tilt movement to the correct starting position.

Adjust PAN/TILT speed
With this function you can define the pan/tilt speed. You can select one of two different modes.

UI Set

Mic Sensitivity
With this function, you can select the desired microphone sensitivity between 0% and 99 %.

1. Select “Mic Sens” by pressing Up or Down.
2. Press the Enter button.
3. Press Up or Down to select the desired sensitivity.
4. Press the Enter button to confirm.

No DMX Status
With the function "No Signal", you can set different modes if there is no DMX signal.

1. Select "Close, Hold, Auto or Music" by pressing Up or Down.
2. Press Up or Down to select between "Close", "Hold", "Auto" or "Music".
3. Press the Enter button to confirm.

Select Temperature Designation
With this function you can select the temperature designation.

1. Select “Temperature C/F” by pressing Up or Down.
2. Press Up or Down to select the desired degree between “Celsius” and “Fahrenheit”.

20 of 27