NORAC UC5-BC-KS01 - Manual (Page 35)

32
10 Connecting the Sensors to the CANbus
1. Fasten the 8-way coupler to the boom with cable ties. Connect cable C03 from the input
module to the 8-way coupler (E11).
2. Connect the main lift sensor to the 8-way coupler using cable C02 and a 2-way coupler
(E12). Cable C02 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.
3. Connect the position sensor (E06) and the active roll cylinder (H75) to the 8-way coupler
using cable C04 and a 2-way coupler (E12).
4. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
5. Attach a 3-way coupler (E10) to the boom at the inner sensor brackets. Connect cable
(C05) to the 8-way coupler and route along the booms to the inner wing sensors. Plug the
sensor and the CANbus cable into the 3-way coupler.
6. Connect cable C05 to the remaining connector on the 3-way coupler and route along the
boom to the outer wing sensors.
7. At the outer sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer
boom. The 2-way coupler with terminator is the white two way coupler. Plug the sensor
and the CANbus cable into the 2-way coupler.
8. Insert the 6 pin plugs (P03) into the remaining receptacles of the 8-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.