NORAC UC5-BC-HG06 - Manual (Page 22)

19
8 Connecting the Sensors to the CANbus
1. Fasten the 8-way coupler (E11) to the boom near the NORAC valve block.
2. Connect cable C05 from the input module to the 8-way coupler.
3. Connect the Intermediate Frame roll sensor to the 8-way coupler.
4. Connect the Boom Frame roll sensor to the 8-way coupler using cable C08 and a 2-way
coupler (E12).
5. Connect the Reference Frame roll sensor to the 3-way coupler between cables C03 and
C09.
6. Connect the main lift sensor to the 8-way coupler using cable C06 and a 2-way coupler
(E12).
7. Attach a 3-way coupler (E10) to the boom at the inner sensor brackets. Connect two
cables (C07) to the 8-way coupler and route along the booms to the inner wing sensors.
Plug the sensor and the CANbus cable into the 3-way coupler.
8. Connect cable C02 to the remaining connector on the 3-way coupler and route along the
boom to the outer wing sensors.
9. At the outer sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer
boom. The 2-way coupler with terminator is the white two way coupler. Plug the sensor
and the CANbus cable (C02) into the 2-way coupler with terminator.
Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
Ensure that all unused connectors are plugged with the plugs provided.