NORAC UC5-BC-HG06 - Manual (Page 18)

15
7 Module Installation
7.1 Control Module
1. Refer to Figure 2 and Figure 12.
2. Mount the control module (E01) in the console (Figure 13).
3. Connect the display cable to the Control Module Display Bus (end of the control module
with only one Deutsch connector).
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Be sure that the power is connected to a switched power supply.
5. Route cable C01 from the other CANbus connector to the cab knock outs.
6. Connect cable C03 to cable C01 at the cab knock outs. Connect a 3-way coupler (E10)
between cable C03 and cable C09. Connect cable C09 to cable C04. Route cable C04
towards the valve block.
Figure 12: Control Module Layout
Figure 13: Control Module Mounting