NORAC UC5-BC-HG06 - Manual (Page 19)

16
7.2 Valve Module
1. Install the valve module (E02) to the top of the NORAC valve block. Orient the 6-pin
Deutsch (CANbus) connectors towards the “P” and “T” ports with the label facing up.
Figure 14: Valve Module
2. Verify the valve coil connectors are oriented vertically (Figure 15).
Figure 15: Align Coils
3. Place the valve module between the valve coils. Slide a valve mounting bracket over the
connectors of the valve module and the valve coil connectors. This may require flexing the
plastic bracket slightly (Figure 16).
4. Ensure the bracket is pushed over the connectors far enough to allow the clips to engage
behind the valve connectors.
5. With the valve module securely mounted to the valve block, connect 2-pin Deutsch plugs
on the valve cable (C10) to the valve coils (Figure 14).
Output
Number
Normal Function
1 Right Up
2 Right Down
3 Left Up
4 Left Down
5 Main Up
6 Main Down
7 Option 3
8 Option 4