NORAC UC5-BC-RG13 - Manual (Page 28)

26
10 Connecting the Sensors to the CANbus
1. Fasten the 8-way coupler (E11) to the boom with cable ties. Connect cable C01 from the
valve module to the 8-way coupler.
2. Connect the chassis roll sensor to the 8-way coupler using cable C02 and a 2-way coupler
(E12). Connect the boom frame roll sensor directly to the 8-way coupler.
3. Connect the main lift sensor to the 8-way coupler using cable C02 and a 2-way coupler
(E12). Cable C04 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.
4. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
5. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
6. Insert the 6-pin plugs (P03) into the unused connectors on the 8-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.