NORAC UC5-BC-RG13 - Manual (Page 19)

17
7.2 Roll Sensor Mounting Guidelines
1. When mounting the roll sensors, mount one to the boom frame (Figure 19) and one to the
chassis (Figure 17) (non-pivoting portion of the sprayer). If the mounting plate shown in
Figure 17 is not installed, use cable ties to mount the chassis roll sensor as shown in Figure
18.
2. Both roll sensor cables should be pointing towards the right hand wing of the sprayer.
3. Ensure both roll sensor cables provide enough slack to allow sufficient boom roll.
Figure 17: Chassis Roll Sensor Mounting
Figure 18: Alternate Chassis Roll Sensor Mounting