NORAC UC5-BC-JD08A - Manual (Page 32)

29
10.4 Roll Cylinder Installation
1. Remove the link arm (black square tube) connected between the parallel lift frame and roll
frame. See Figure 29 for the link arm location.
Figure 29: John Deere Link Arm Location (looking towards rear of sprayer)
2. Remove the lower link bolt and nut.
3. Roll the intermediate frame (where the link is still attached) counterclockwise until the
upper link pin can be accessed. It may be helpful to use a jack or strap between the boom
frame and the intermediate frame. Remove the snap-ring from the link pin. Remove the
pin and link.
4. Install the cylinder (H75) into the lower mount so that the cylinder ports face the front of
the sprayer. Ensure the pivot sleeve is installed into the cylinder. Install the bolt through
the cylinder and sleeve and torque to 250 ft-lbs (339 Nm).
Figure 30: Lower Bolt Installation
Link Arm
Position