NORAC UC5-BC-JD08A - Manual (Page 31)

28
10.3 Valve Block Mounting
1. A good mounting location for the valve block on the John Deere is illustrated in Figure 28.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 28: Valve Block Mounting