NORAC UC5-BC-GV01 - Manual (Page 26)

23
10.2 Valve Block Mounting
1. Mount the valve block on the center section of the boom as illustrated in Figure 25.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 25: Valve Block Mounting