beautypg.com

2 control module: pull type sprayer – NORAC UC5-BC-GN01 User Manual

Page 25

background image



22

8.2 Control Module: Pull Type Sprayer

1. Refer to Figure 2 and Figure 23.

2. Refer to the display kit installation manual to determine the best mounting location for the

control module (E01).

3. Connect the display terminal to the control module using the display CANbus cable. This

cable must be connected to the end of the control module with only one Deutsch
connector.

4. Connect the existing power cable to one of the two CANbus connectors on the other end

of the control module.

5. Route cable C01 from the other CANbus connector towards the rear of the sprayer.

Figure 23: Control Module Mounting (Pull Type Sprayer)

See also other documents in the category NORAC Gardening equipment: