8 module installation, 1 control module: self propel sprayer – NORAC UC5-BC-GN01 User Manual
Page 24
21
8 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item
Part Number
Name
Quantity
B20
43708
UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES)
1
8.1 Control Module: Self Propel Sprayer
1. Refer to Figure 1 and Figure 22.
2. Securely mount the control module (E01) inside the sprayer cab using screws, cable ties or
optional brackets.
3. Connect the display terminal to the control module using the existing display cable. This
cable must be connected to the end of the control module with only one Deutsch
connector.
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Connect the other end of the power cable to an appropriate power source.
5. Route cable C01 from the other CANbus connector towards the rear of the sprayer.
Figure 22: Control Module Mounting (Self Propel Sprayer)
Cable C30 is shown in Figure 22 for informational purposes only. The battery cable
is ordered separately from this kit and may differ from the diagram above.