NORAC UC4+BC+HG4 - Manual (Page 19)

16
4.5 E
LECTRICAL
I
NSTALLATION
1. Install the UC4+ Control Panel (E01) in
the cab of the sprayer. Mount the panel
where it will be clearly visible and within
easy reach of the operator.
In the Hagie cab, a good spot to
mount the UC4+ control panel is
on the right hand side of the cab,
next to the spray controller
Figure 19: Control Panel Mounting
If mounting the panel to a round
pole, use the rail mount adapter
kit (B06) (Figure 20).
Figure 20: Mounting the Control
Panel Using the Adapter Kit (B06)
2. Cable C05 can be teed in between the
sensor on the linear roll cylinder and
the wiring harness.
3. Route the other end of C05 to the main
lift sensor.
4. Cable-tie installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.