NORAC UC4+BC+HG4 - Manual (Page 17)

14
4. Align the spring target by rotating the
metal casing around the linear roll
cylinder.
5. Mount the sensor bracket to the
damper end (the end with no hoses). A
straight edge can be used to line up the
spring target with the center of the hole
on the sensor mounting bracket.
6. Mount the boom target to the cylinder
end (the end with hoses).
7. Install the cylinder target (bottom rod)
so that it is 5/8” to the side of the
spring target (Figure 18).
8. Install a sensor (E02) into the sensor
mounting bracket.
Figure 18: Linear Roll Cylinder Target Alignment
Top View
Side View