NORAC UC4+BC+HD8A - Manual (Page 18)

15
4. Align the spring target by rotating the metal
casing around the linear roll cylinder.
5. Mount the sensor bracket to the damper
end (the end with no hoses). A straight
edge can be used to line up the spring target
with the center of the hole on the sensor
mounting bracket.
6. Mount the boom target to the cylinder end
(the end with hoses).
7. Install the cylinder target (bottom rod) so
that it is 5/8” to the side of the spring target
(Figure 16).
8. Install a sensor onto the sensor mounting
bracket.
Figure 16: Linear Roll Cylinder Target Alignment
Top View
Side View Side View - Installed
Sensor
Mount
Spring
Target
Cylinder
Target
10”
(255mm)
36.5”
(926mm)