NORAC UC4+BC+FT2 - Manual (Page 19)

16
Figure 17: Valve Cable Connections
8. Connect the sensor branch cable (C02)
to the 4-pin AMP plug (P4) on C11
(Figure 18).
9. Route the sensor branch cable (C02) to
the wing and linear roll cylinder sensors.
Follow existing cables and/or hydraulic
lines along the boom.
10. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.
Figure 18: Cable Configurations: C02,
C02B and C11