NORAC UC4+BC+FT2 - Manual (Page 15)

12
4.2.3 Inverted Roll Sensor Mounting
If desired, the Roll sensor may be mounted
inverted, so long as the connector exits
towards the right-hand boom. Inverted
mounting may be used to optimize the
mounting criteria explained in Section 4.2.
Figure 12: Inverted Roll Sensor Mounting may be Applicable for Optimal
Performance
4.2.4 Temperature Probe
Fasten the temperature probe (E03) to the
UC4 valve block using the included 3/8x1/2”
bolt as illustrated in Figure 13.
Figure 13: UC4+ Valve Block with
Temperature Probe Installed