NORAC UC4+BC+SC4 - Manual (Page 22)

19
Figure 23: Cable Configurations: C10, C02 and C03
9. Connect the 6-pin Tower on the Valve
Cable (C03) to the mating 6-pin Shroud on
C10 at the rear of the sprayer and route to
the NORAC valve block (Figure 23).
19.
The connectors on the valve cable (C03)
are marked RIGHT UP, LEFT UP,
RIGHT DOWN and LEFT DOWN.
Cables labeled with UP go on the same side
as the hydraulic hoses.
Figure 24: Valve Cable Connections
20. Connect the sensor branch cable (C02) to
the 4-pin AMP plug on C10.
21. Route the long branches of the sensor
branch cable (C02) to the wing sensors and
connect. Follow existing cables and/or
hydraulic lines along the boom.
22. Route the short branch of cable C02 to the
roll sensor and connect.
23. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the main
section, parallel lift, and FOLDING boom
movement.