NORAC UC4+BC+SC4 User Manual
Page 21
18
Figure 21: Access Hatch in Front of Seat
2. Route cable C10 into the cab into the cab.
Ensure that the cable is not wrapped around
the drive shaft beneath the sprayer.
3. The access hole can be located either
beneath the dash (Figure 20) or in front of
the seat (Figure 21). There is a removable
access plate beneath the dash (on the left,
towards the door). A slot may be cut in the
access plate so that it can be replaced
(Figure 20). It is recommended to use a
rubber grommet in the cutout slot to avoid
cable damage.
4. Connect the UC4+ Interface Cable (C10) to
the UC4+ Control Panel (E01) in the
sprayer cab.
Ensure the UC4 Control Panel’s
power is OFF for the remaining
installation (Bottom of switch
pressed IN).
5. Connect the ring terminal connections on
cable C10 to a 12V, 15 amp source.
6. Route C10 to the back of the sprayer.
7. Route the end of C10 with the 2-pin
Deutsch and 2-pin weatherpack connectors
to the SpraCoupe Bypass/Jam valve (Figure
22).
8. Disconnect the SpraCoupe 2-pin connectors
at the Bypass/Jam valve and insert either
the 2-pin Deutsch or 2-pin weatherpack
connector tee (depending on the sprayer)
on C10 between them. Connect the
unused connectors on cable C10 together.
Figure 22: Bypass/Jam Valve Location
Bypass/Jam
Valve