NORAC UC4+BC+SC4 - Manual (Page 13)

10
number on the left hand side
proceeding to the largest serial
number on the right hand side
(Figure 11).
5. Sensor cables should run through the
mounting bracket tube and then behind the
member the bracket is mounted onto.
Cable-tie the connector in place. The cable
must not be allowed to hang below the
boom (Figure 6).
Figure 6: Another Acceptable Mounting
Avoid mounting sensors in
locations where they may read
from parts of the boom as shown in
Figure 7.
Figure 7: Poor Mounting
(Sensor Reading off Boom)
General mounting rules for UC4+
ultrasonic wing sensors:
a)
In its lowest position, the sensor mouth
must be 9 inches or more from the
ground.
b)
The bottom of the sensor must be at
least 9 inches in front of the spray
nozzles.
c)
The bottom of the sensor must be at
least 9 inches above the spray nozzles.
d)
Ensure that there are no obstructions
within a 12-inch diameter circle
projected directly below the center of
the sensor.
e)
The sensor should be approximately
vertical at normal operating heights.
Figure 8: Sensor Mounting Guidelines
A
B
B
D
C
Ultrasonic
Acoustic Cone