NORAC UC4+BC+SC2 - Manual (Page 23)

20
Figure 22: How to Tee in the “B” (Raise) Line
24. Install hose H03 onto the tee fitting.
25. Route hose H03 to the NORAC valve block
and attach it to the 90 degree adapter on
the “B” port.
26. Remove the 12MB 12MB orifice fitting
installed between the gold accumulator
block and tilt cylinder. Replace the fitting
with the 12MB 12MB fitting (F08).
Figure 23: Fitting Between the Cylinder
and Accumulator Block to be Replaced
27. Remove the accumulator from the block.
28. Remove the 8MB 8MB fitting from the gold
block. Turn the fitting over and reinstall it
into the block so the adjustable end is facing
up, where the accumulator will thread on.
29. Install the orifice insert (F09) inside the
accumulator. Reattach the accumulator with
the orifice inside.
Figure 24: Orifice Insert Installed in the
Accumulator
Replace this
fitting with
F08
Steel Line
Hose to accumulator
block
NORAC “B”
Line