NORAC UC4+BC+JD8 Update - Manual (Page 14)

5 Software Setup
Firmware must be updated to Update Package 1094 or higher for UC5™ and
Version 7D or higher for UC4+™ before proceeding.
1.
Start up your sprayer and test the sprayer’s functionality. The display terminal does not
need to be powered on for the original boom function switches to operate. Unfold the
booms and raise/lower each boom and the main section.
Confirm that the cabling and hoses are routed properly over the entire range of
boom motion and folding.
2.
If any functions do not work, review the hydraulic portion of this manual to check for
proper installation.
3.
Turn on the power for the display terminal.
4.
Perform the AUTOMATIC SYSTEM SETUP procedure as described in the UC5™ and
UC4+™ Spray Height Control Operator’s Manuals.