4 friction pad greasing – NORAC UC4+BC+JD8 Update User Manual

Page 13

Text mode
Original mode

4 Friction Pad Greasing

NOTE: This applies to both Active Roll™ and Passive Roll™ updates.

For good performance it is recommended that the friction pads be greased. Before calibrating
the software grease the sliding pads. Manually rotate the boom (by pushing on the ends) to
access the entire surface of the pads when greasing.

It is recommended that the pads be re-coated with grease every 20 hours of
operation.

Figure 13: Sliding Pad Locations