NORAC UC4+BC+CS3 - Manual (Page 25)

22
Figure 26: Cable Configurations: C10, C11 and C14
2. Connect the UC4+ power cable (C10)
to the UC4+ control panel in the
sprayer cab. Ensure both plugs (P16
and P4) are connected to the panel.
3. Connect the 3-pin AMP plug (P3) on
C10 to the 3-pin AMP receptacle (R3)
on the power pigtail interface cable
(C14). Splice the pigtails on C14 into
the existing wiring.
Ensure the UC4 control panel’s
power is OFF for the remaining
installation (Bottom of switch
pressed IN). Use caution when
handling the 12 V power line of
the existing wiring.
4. Route the receptacle end (R16) of C10
out of the cab.
5. Connect the 16-pin AMP plug (P16) of
the valve extension cable (C11) to R16
of C10 on the outside of the cab
(Figure 26).