NORAC UC4+BC+CS3 - Manual (Page 23)

20
4.6.4 120’ Boom Orifice Installation
If the kit is being installed onto a
120’ boom, it is recommended
that an orifice be installed in each
wing cylinder accumulator. This
is not necessary for booms
without accumulators.
1. Before continuing, make sure the booms
are lowered all the way to the bottom of
the cylinder travel.
2. Place one of the o-rings (F10) into the o-
ring groove on the inline orifice (F11).
3. Remove the wing accumulator and insert
the inline orifice (F11) between the
accumulator and fitting.
4. Reassemble and repeat for the opposite
tilt cylinder.
Figure 24: Tilt Cylinder Accumulator
Location
Orifice location
on wing cylinder