NORAC UC4.5-SM3 - Manual (Page 14)

11
3. Install the two connectors on the end of cable C17 to the expansion block. The connector
marked “Main Up” goes on the port side of the block. The port side of the block is the side
with the hoses.
4. Disconnect P6 on C11 from the 8-way coupler (E11).
5. Connect P6 on C11, C07 and the roll sensor connector (E04) to the 3-way coupler (E10).
6. Connect the free end of C07 to the 8-way coupler.
7. Connect the main lift sensor to the 8-way coupler using cable C07 and a 2-way coupler
(E12). Cable C07 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.