NORAC UC4.5-SM3 - Manual (Page 12)

9
3. The roll sensor is to be mounted onto the chassis as shown in Figure 6. Ensure the roll
sensor is relatively level when chassis is level.
Figure 6: Chassis Roll Sensor Mounting
4. Ensure that the chassis roll sensor (Figure 6) has the highest serial number and that the
boom frame roll sensor (previously installed) has the lowest serial number (Figure 7).
Figure 7: Boom Frame and Intermediate Frame Roll Sensors (Previously Installed)
5. Ensure roll sensors are mounted adequately and that the cables provide enough slack to
allow sufficient boom roll.
Intermediate
Frame Roll
Sensor
Boom Frame
Roll Sensor