NORAC UC4.5-BC-SS1 - Manual (Page 22)

19
8.2 Valve Block Mounting
Ensure that no hydraulic components will interfere with any sprayer parts or be
pulled tight at any time.
The recommended mounting location is on the cross beam between the
parallel lift arms on the main section.
1. A suitable mounting location for the valve block is illustrated in Figure 20.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 20: Valve Block Mounting