NORAC UC4.5-BC-RG4 - Manual (Page 21)

18
5. In the electrical panel towards the front of the sprayer, wire the white wire on C30 to
+12V and the black wire to Ground. Refer to Figure 15 for recommended +12V and
Ground connections inside of the electrical panel.
Figure 15: Power and Ground Connections
5. Route P12/P6 of C10 to the exterior of the cab. There is an access panel located on the
front right corner of the cab floor. It can be removed to allow cables to be routed to the
exterior of the cab. Use this panel to route P12/P6 through the hole of the provided
access panel kit (B16) (Figure 16). B16 maintains the cab seal. Leave the cover plates
unscrewed at this point. Figure 17 shows the access panel and the installed plates.
6. Connect R12/R6 of C11 to P12/P6 of C10 outside of the cab.
Figure 16: Access Plates Configurations
Connect Ground
Wire Here
Connect +12V
Wire Here