NORAC UC4.5-BC-NT4 - Manual (Page 22)

19
7.3 Both Installations
1. Connect R12/R6 on C14 to P12/P6 on C10.
2. Route the four metri-pack connectors on C14 to the rear of the sprayer, in the vicinity of
the main lift valve block.
3. Disconnect the sprayer’s metri-pack tower labeled MM13 and connect it to the shroud
from C14 labeled “MAIN UP”. Connect the tower on C14 labeled “MAIN UP” to the
sprayer solenoid that was disconnected.
4. Disconnect the sprayer’s metri-pack connector labeled MM14 and connect it to the shroud
on C14 labeled “MAIN DOWN”. Connect the tower on C14 labeled “MAIN DOWN” to
the sprayer solenoid that was disconnected.
Figure 21: Nitro Main Section Valve Connector
Figure 22: Main Lift Wiring Connections
Main Lift Connectors
MM13 and MM14