NORAC UC4.5-BC-NT4 - Manual (Page 21)

18
3. There is an access hole located in the front right corner of the cab floor that can be seen
when the floor mat is lifted. Access plate (B16) which maintain the cab seal are provided in
the UC4.5 kit. Rout C10 through the large hole in the access plate (Figure 19).
Leave the cover plates (B16) unscrewed at this point.
Figure 19: Access Plate Configuration
7.2 5000 Series Installation
1. Connect C31 to P6A on C10 using the 2-way coupler (E12). Connect the 3-pin connector
on C31 to power in the cab.
2. Route Cable C10 out of the cab through the rear right side access hatch.
Figure 20: Cable Configurations: C10, C14 and C31