NORAC UC4.5-BC-JD8 - Manual (Page 24)

22
5. Remove the plug from the Sense Line Bleed port. Location is shown in Figure 24. Gently
tap the plug with a hammer to loosen it before attempting to remove it. Remove the Sense
Line Bleed Orifice and discard.
6. Install the setscrew (F15) into the Sense Line Bleed Orifice location. Ensure the setscrew is
threaded entirely into the hole and tightened to 35-40 in-lbs to ensure a tight seal. Reinstall
the plug and tighten to 35-40 in-lbs.
Figure 24: Load Sense Bleed Orifice Location on Top of Block