NORAC UC4.5-BC-JD7 - Manual (Page 20)

18 18
The hole in the floor may be covered by a plate, or a grommet may be
installed in the hole. They can be reinstalled after the wiring is complete.
NORAC supplies a grommet (M13) for the hole if one does not exist.
Figure 17 – Hole under Floor Mat
The cables may also be routed through the rear window of the cab.
6. Plug in the 6-pin tower on C10 to the 6-pin shroud on the valve extension cable (C04).
C04 comes with one connector (M16) unassembled to allow the cable to be
run through a hole in the floor under the steering column. To assemble this
connector (M16), refer to the drawing in Section 10. The pins require a special
tool to remove them if an error is made.
7. Route the free ends of C06 and C04 to the rear of the sprayer near the sprayer valve block.
Run the cables along the sprayer frame with the JD harness.
Figure 18: Cable Configurations: C12, C03 and C04