Mytek Digital Protools HD DIO Card (ver. 1.1 / Oct 2010) - Manual (Page 4)

Mytek Protools-HD DIO Card – User Manual
Introduction
The Mytek Protools-HD DIO Card is a physical card that plugs
into the back of the Mytek 8X192 ADDA converter.
With this card installed the Mytek 8X192 ADDA can be directly
connected to the Core, Process or Accel interface cards of
Digidesign Pro Tools HD ® systems.
The card may be installed by the user as described further in the
manual. The 8X192ADDA with the card installed will be
recognized by Protools HD® software as an emulated HD192
interface.
Before You Begin
Before connecting the DIO-HD card check if the most current
firmware (version 4.5.3 or later) is installed in the
8X192 converter. To verify the version locate the firmware chip
on the main converter board, or please contact Mytek for
additional assistance.
(If necessary contact Mytek to request appropriate firmware.)
User Manual ver. 1.1 / oct 2010 www.mytekdigital.com Page: 4 / 29