MF Digital OptiEC Pro 6 - Manual (Page 21)

U Us si in ng g t th he e O Op pt ti iE EC C P Pr ro o P Pr ri in nt te er r 6 6 w wi it th h W Wi in nd do ow ws s 1 17 7
Making this number smaller will allow you to print closer to the
center hub, but be aware that ink printing on non printable
surfaces at the center of the disc will not dry and can spin off
into a drive.
The Cartridge Alignment button will perform a test print to
calibrate CMY cartridge to the Kmc photo cartridge as well as
the printing and also the color-to-black offset values. Place a
CD in the disc tray before clicking on this button. Your print
should look something like this:
After the test print is completed, examine the lines displayed
after A,B,C and D. Each of the lines will have a number
associated with it. Enter the number for the straightest line for
for A,B,C and D in the space provided in the software.
Centering the Print Image contains options to allow you to
make sure images are aligned properly on the media.
NOTE: Your printer comes from the factory pre-calibrated to print the
image in the center of the CD. You can use this adjustment if
you need to fine-tune this location.
If you ever wish to verify your factory-calibrated Vertical and
Horizontal calibration settings, you can run a simple calibration
procedure to assure that your images will be centered when
printed on a CD. To do this, refer to the following steps:
1. Verify that a disc and a color ink cartridge are installed in
the printer. It is important to use the same disc you
0 4 8 12
13
14
15
10
11
9 5 1
6
7 3
2
14 12 10 8 6 4 2 0
10 12 14 16 18
10 12 14 16 18 0 2 4 6 8
0 2 4 6 8
A
B
C
D