Make Noise Analog Memory - Manual (Page 3)

3
Proper installation of included power cable on mod-
ule. Please note the RED BAND.
Installation:
The Make Noise Analog Memory is an electronic signal generator
requiring 20mA of +12V regulated power and properly formatted
distribution receptacle to operate. It is designed to be used within the euro
format modular synthesizer system.
Go to http://www.doepfer.de/a100_man/a100t_e.htm
for the details of this format.
To install, find 20HP of space in your euro-rack synthesizer system directly
above or adjacent to the Pressure Points which will connect to the Analog
Memory.
Power Cable:
Confirm proper installation of included power cable on backside of module
(see picture below). Once the EXPAND and CHAIN cables are installed, plug
the 16pin end power cable into the euro-rack style power distribution board,
minding the polarity so that the RED stripe on the cable is oriented to the
NEGATIVE 12 volt supply line. This is USUALLY at the bottom. Please refer to
your case manufacturers’ specifications for location of the negative supply.