Longshine LCS-GS9428 - Manual (Page 6)

6
LED for each port:
The switch provides one “1000M” LED and one “10/100M” LED for each port.
1000M LED: Shows the current transmitting/receiving speed of the
port.
10/100M LED: Shows the link status and the activities on the port.
LED Status Operation
Green The port is connected at 1000 Mbps
Blinking Green A valid link is established, and there is data
transmitting/receiving. 1000M
Off
No valid link on this port or the Port is connected at
10/100 Mbps
Steady Green A valid link is established, and there is no data
transmitting/receiving.
Blinking Green A valid link is established, and there is data
transmitting/receiving.
10/100M
Off
No valid link on this port or the port is connected at
1000 Mbps
Port Operation
The auto-negotiation feature allows those ports running at one of the
following operation modes:
Media Speed Duplex Mode
Full Duplex 10Mbps
Half Duplex
Full Duplex
100Mbps
Half Duplex
10/100/1000Mbps(copper)
1000Mbps Full Duplex
1000Mbps(Fiber)
(mini GBIC required) 1000Mbps Full Duplex
Note: For the last port, when both the fiber and cooper interfaces are
connected, the system adapts the fiber interface and disables the relevant
cooper port automatically.
Attention：The Mini GBIC slot shares the same LED indicator with the
last 4 RJ-45 (copper) port.