Longshine LCS-GS9428 - Manual (Page 43)

43
SNMP Setup [enable|disable]
Description:
Activate or deactivate the SNMP.
[enable|disable]: Enable/disable SNMP (default: Show SNMP mode).
SNMP Trap []
Description:
Set or show SNMP traps destination.
: IP address to send traps to. (default: Show trap
configuration)
Ratelimit Commands
Commands at Ratelimit level:
Ratelimit Configuration
Ratelimit Setup
Ratelimit Egress [] [enable|disable] []
Ratelimit Ingress[] [enable|disable] []
[] :Port list (default: All ports).
[enable|disable] :Enable or disable.
[] :Set leaky bucket rate in Kbit/s[128/256/512/1024/2048/3072K]
(default: Show rate).
Ratelimit Configuration
Description:
Show the Ratelimit setting.
Ratelimit Setup
Description:
Set or show the ratelimit configuration. The allowed frame rates for
ICMP frames, learn frames, multicasts, broadcasts and flooded unicasts are
controlled using a central ratelimit.
[] : Ratelimit to set. Can be one of:
[ICMP|Broadcast|Multicast]
(default: Show all).
[enable|disable] : Enable or disable specified ratelimit.
[] : Frame rate in kiloframes
Allowed values are 1k, 2k, 4k, 8k, 16k, 32k, 64k,